MenuSearch | Country: United States | Currency: USD
NX-5000 V1 550W Real Silent Compact ATX Power Supply
Discontinued
More variations available Show

Nexus NX-5000 V1 550W Real Silent Compact ATX Power Supply

Nexus power supplies have been best sellers since their introduction in 2003. Nexus has put their engineers to work to improve the product in every aspect possible. The new NX-5000 V1 has more power, has a higher efficiency and is quieter!

Compared to its predecessor, the new Nexus NX-5000 V1 has more power (550W), a higher efficiency, compliant to ErP2013 and still with the same noise levels. The NX-5000 provides 550 Watt True Power and the efficiency level meets the 85 Plus standard. The new NX-5000 has kept the black and white appearance and the small chassis which fits inside standard ATX cases. The system benefits from this small chassis as there is more room for airflow and cooling.

Features

  1. Single 550W 12V rail PSU
  2. High efficiency (over 85% at all levels)
  3. Sleeved cables with X-mesh
  4. Active PFC
  5. Real Silent 12cm fan, from 15dB(A)
  6. Excellent airflow, honey-comb grill
  7. Full range automatic; auto voltage selection
  8. Multiple safety features such as: overvoltage and short-circuit protection

By carefully selecting each component Nexus aim at creating the best possible of mix of components to make our power supplies as quiet as possible. They are confident that their power supplies are leading the market when it comes to solid performance at the lowest possible noise level. All Nexus’ PSUs are tested in a ISO-certified chamber for noise tests. It is important to know that the background noise in such a chamber is a little over 15 dB(A). These are the best possible conditions for these tests.

The Nexus NX-5000 V1 power supply is guaranteed to provide at least 85% efficiency. This means the power supply is using the power it is drawing from the wall outlet more efficiently and therefore less electricity is wasted. Obviously this is better for the environment and helps to reduce the electricity bill! Also, a more efficient power supply also results in a cooler power supply.

ErP2013

This power supply is an ErP2013 power supply, which means your PSU is not using more than 0.5W at standby mode.

SpecificationsNX-5000 V1
ATX12V Versionv2.2
20+4-pin ATX ConnectorYes
ATX12V (4-pin) supportYes
EPS12V (4+4-pin) supportYes
EPS12V (4-pin) supportNo
PCI-E supportYes, 1x 6+2-pin and 1x 6-pin
Number of floppy drive connectors1
Number of hard drive connectors3
Number of SATA power connectors6
Master power on/off switchYes
Acoustic noise levelFrom 15 dB(A)
Fan size120mm, thermally controlled
Length of motherboard power cable35 cm (approx)
+3.3V maximum output current20 A
+5V maximum output current20 A
+12V maximum output current43 A
-12V maximum output current0.5 A
+5VSB maximum standby current2.5 A
Combined maximum output +3.3V / +5V100 W
Mains input voltageFull range automatic
Physical dimensions86 x 150 x 125 mm
CertificatesCE, WEEE, RoHS, UL, CB, TUV, FCC, ErP2013
Warranty24 months
EAN barcode8717371696962
SpecificationsNX-5000 V1
ATX12V Versionv2.2
20+4-pin ATX ConnectorYes
ATX12V (4-pin) supportYes
EPS12V (4+4-pin) supportYes
EPS12V (4-pin) supportNo
PCI-E supportYes, 1x 6+2-pin and 1x 6-pin
Number of floppy drive connectors1
Number of hard drive connectors3
Number of SATA power connectors6
Master power on/off switchYes
Acoustic noise levelFrom 15 dB(A)
Fan size120mm, thermally controlled
Length of motherboard power cable35 cm (approx)
+3.3V maximum output current20 A
+5V maximum output current20 A
+12V maximum output current43 A
-12V maximum output current0.5 A
+5VSB maximum standby current2.5 A
Combined maximum output +3.3V / +5V100 W
Mains input voltageFull range automatic
Physical dimensions86 x 150 x 125 mm
CertificatesCE, WEEE, RoHS, UL, CB, TUV, FCC, ErP2013
Warranty24 months
EAN barcode8717371696962

FAQ

  • Do high wattage power supplies cost more to run?

    No - the rated wattage of a power supply refers to the maximum amount of power it can deliver at full load, not how much power it uses. More powerful PSUs will consume around the same amount of power as lower powered power supplies in any given PC system, so your electricity bill will not be higher when using a more powerful power supply!

    The best way to reduce your electricity bill when using your PC is to use a more efficient power supply or make your PC consume less power by removing components which are not needed, such as extra drives and expansion cards, or by choosing a cooler-running processor or graphics card.

  • My brand new power supply doesn’t work! Am I doing something wrong?

    It’s possible that the power supply may be faulty, but here are some simple things to check. Firstly, a power supply will not work if you simply plug it in and flick the switch. The power supply will only turn on if you connect it to a working motherboard and associated items (processor, memory, video card, etc). It is actually the motherboard which tells the power supply when to switch on.

    Secondly (if applicable), check the voltage is set correctly to 115/230 volts depending on what country you are in. Thirdly, if possible it would be good to try the power supply in another PC to see if it works, or try another power supply in your PC to see if that works. You can then tell whether it is the power supply which is faulty or the actual PC itself. If all else fails, please contact us for further support, and/or return details.

  • Why should I buy a whole new PSU when I could just replace the noisy fan in my existing one?

    Virtually all the noise generated by a PC power supply originates from the cooling fan inside it, so simply replacing the fan with a quiet fan may seem an obvious way to go. However, if you are thinking about attempting this operation, please bear the following points in mind:

    • Your existing power supply will be designed to run with a specific amount of airflow in order to adequately cool the components inside and reducing the airflow may lead to overheating and damage to the power supply and/or PC.
    • All PC power supplies contain very high voltages and even with the power disconnected, the voltages stored in the capacitors can be easily enough to kill. It is not recommended to take the cover off any PC power supply for this reason unless you are absolutely confident of your own ability. Because of the grave dangers involved, all PC power supplies by law carry a warning label forbidding removal of the power supply case.
    • There will be no standard PC fan connector inside the power supply to use to connect a replacement fan, and it would probably have to be soldered directly into the PCB inside the power supply, or have a specialist power connector attached. This can be a tricky operation to say the least.

    Please consider the above points very carefully before proceeding with an operation to replace the fan in your existing power supply!

  • What is PFC (Power Factor Correction)?

    If you are interested in being “green” and saving the planet, you might like to read a short explanation of how our power supplies can save energy using Active PFC (Power Factor Correction), not to be confused with Power Conversion Efficiency which is also very good in most of our PSUs. “Power Factor” is a measure of how efficiently electrical power is consumed. Ideally, Power Factor would be 1 (or 100%) and known as unity.

    Unfortunately in the real world, Power Factor is reduced by highly inductive loads down to values of 0.7 (70%) or less. This induction is caused by equipment such as small electric motors, fans, fluorescent lighting ballasts and transformers such as those in PSUs. This is bad news for the electricity generating companies who can impose a surcharge on heavy users if they have a consistently low Power Factor, as more electricity has to be produced to make up the shortfall.

    Power Factor Correction (PFC) is used in some equipment to minimise the inductive component of the electrical current. This helps to reduce the losses in the electrical supply to that equipment. Power Factor Correction capacitors are normally used to reduce induction in an electrical load, which minimises wasted energy and hence improves the efficiency of a company and reduces electricity costs.

    It is not usually practical to reach unity, i.e. Power Factor 1, and it seems that most electricity supply companies accept consumers having a Power Factor as low as 0.94 (94%) without imposing a surcharge. Unfortunately most of the cheap (and not so cheerful) PSUs tend to have a Passive PF as low as 0.75 or 75% which in a large office can lead to a PF surcharge.

    However, the good news is that most of Quiet PC’s PSUs implement a system known as Active PFC which involves some clever electronics. This means that their power factor (PF) can be as high as 0.94 or 94% (at full load), while harmful harmonic frequencies are reduced to well below legal requirements. So by using our products, you can be happy in the knowledge that you are doing your bit to save the planet!

  • How do I know what size of wattage power supply I need?

    The best answer we can give to this question is to go ahead and take an intelligent “guesstimate”! There are no hard and fast rules about what size of power supply any given PC needs as a minimum. Our advice would be that if you are replacing an existing power supply, then consider a new one at least of the same wattage as the old one. In addition, if you wish to build in a “safety margin” to allow for reliable running and possible future upgrades, consider adding 100-200 watts to the rating of your existing unit.

    If you are building a new PC, most customers now buy a power supply rated in the region of 500-800 watts depending primarily on the performance level of their graphics card(s) and number of drives to be installed. But in any event if you are unsure about which power supply would be best for your PC then please do contact us by phone or email and we will be happy to give you a specific recommendation based on your budget.

  • My new PSU came with a 24-pin connector but my motherboard needs 20 pins! Do I need an adaptor cable?

    We receive many customer enquiries about this. In fact, most of the 24-pin compatible power supplies we sell come with special motherboard connectors which can be converted to 20-pins with no additional conversion cables. All you need to do is look carefully at the connector and you will see that the end four pins can be slid off, turning the connector into a 20-pin compatible one (see below) - easy when you know how!

    Image showing how to change a power supply’s 24-pin motherboard connector into a 20-pin connector by unclipping the end four-pin block
    Image showing how to change a power supply’s 24-pin motherboard connector into a 20-pin connector by unclipping the end four-pin block
  • What do the PSU safety protection abbreviations mean?

    There are many possible safety protections a PSU can have. Below is a list of what each abbreviation means. Please note, not all PSUs have all safety protections.

    More information on certification marks can be found here.

Top Quiet Power Supplies

Recently Viewed Products